Republic Airways Interview Practice Test

These questions are part of the practice quiz. Start practicing

• What are the requirements to descend below MDA/DH?
• When the ILS glideslope component is out of service, which approach method is used in determining the missed approach point?
• What is required when descending below DA/MDA to 100 feet above TDZE?
• What action should you take during a walk-around inspection if you notice frost on the engine nacelle?
• From how far from the airport should the field altimeter setting be set?
• What is a critical aspect of maintaining a stabilized approach?
• How is RVR typically measured?
• If the ILS glideslope component is out of service, how do you determine the missed approach point?
• What is virga and what does it indicate?
• What consideration must be taken into account if rejecting a takeoff beyond V2?
• What are the standard takeoff minimums under Part 121?
• Why is it important to monitor the frost on the aircraft?
• How can one avoid wake turbulence when landing behind a larger aircraft?
• What is the speed limit for aircraft flying below 10,000 feet?
• What defines the missed approach point on a precision approach?
• What is the guaranteed vertical clearance provided by the MSA?
• Define "instrument conditions"?
• How many miles does a TAF extend around an airport?
• What does "plate dependent" refer to in altitude descending situations?
• What are the altitude limits for Class A airspace?
• What is prohibited when flying in Class Bravo airspace at 250 KIAS?
• What does airport beacon operation during the day indicate?
• What environmental condition typically signals the presence of upslope fog?
• What is hypoxia?
• What is the transponder code for lost communication?
• How frequently can turbulence be described?
• When experiencing a tailwind, what is the recommended action to achieve the best range for your aircraft's performance?
• In aviation, what does the term 'current aircraft limitations' refer to?
• What does MEL stand for in aviation terminology?
• What are the three types of fog?
• What symptom could indicate hypoxia?
• What is the main goal of reading METAR and TAF reports?
• What is the transponder code for emergency?
• What type of observations is determined by evaluating METAR and TAF data?
• How is clear air turbulence defined?
• What occurs when a pilot decreases cruise speed in the presence of a tailwind?
• At the DA/MDA, what is required to continue descent to landing?
• What does D-ATIS on the approach plate indicate?
• How does the holding speed change for different altitudes in airspace?
• What is the standard temperature lapse rate?
• What does RVR stand for in aviation?
• At what altitude would you fly a visual traffic pattern in a turbine-powered aircraft?
• If ATC asks for "best forward speed" in Class Bravo airspace, can you exceed 250 KIAS?
• How often are VOR checks required for IFR operations?
• Is altitude usually referenced in MSL or AGL on approach charts?
• In terms of aircraft safety, what function does V1 provide?
• Where does the touchdown zone of the runway begin and end?
• What is the missed approach procedure for an approach?
• What is a Minimum Vectoring Altitude (MVA)?
• In aviation, what does the term 'takeoff alternate' refer to?
• What is the purpose of the IMSAFE checklist in aviation?
• What altitude requires the remaining pilot to wear supplemental oxygen?
• What should a pilot reference to learn about the last changes on an approach plate?
• When can you descend below the glideslope when landing on a runway served by a VASI?
• How far does the MSA extend horizontally from the airport?
• What is one method for overcoming the effects of a Dutch roll in aviation?
• What is the role of METAR in flight operations?
• What is required for an alternate airport in relation to weather at the time of arrival?
• In aviation, when referring to speed, does 120 knots refer to indicated airspeed or ground speed?
• When can a descent from a previously assigned altitude on approach be initiated?
• How is V1 defined in aviation terms?
• How soon before reaching an assigned holding fix should pilots begin to slow to the assigned holding speed?
• What is the maximum holding speed for aircraft at 5,000 feet?
• When discussing the requirement for an alternate airport, which rule is typically referenced?
• What does UUA indicate in a PIREP?
• When reviewing weather conditions, what does a TAF stand for?
• What is the function of fusible plugs in aircraft tire assemblies?
• To what distance does the Localizer signal provide guidance?
• If your groundspeed is 480 knots, how many miles per minute are you traveling?
• What is one of the main advantages of flying a jet aircraft at higher altitudes?
• What performance metrics are evaluated in terms of fuel efficiency and distance traveled?
• What can be a direct result of flying with fatigue?
• What is induced drag?
• Does a tower clearance to land and hold short of another runway have to be accepted?
• How far do touchdown zone lights extend from the threshold?
• What is commonly the quickest way to understand missed approach procedures?
• What should the altimeter be set to when climbing through 18,000'?
• At what altitude is it appropriate to turn towards your first fix or heading after departure?
• When assigned a speed of 210 KIAS while being vectored for an approach, when is it permissible to change that speed?
• On a non-precision approach, how is the missed approach point determined?
• If a pilot has the required flight visibility, what can they do when reaching DA/MDA?
• Which type of drag generates air resistance due to any non-lift-producing aircraft part?
• What speed must you slow to if descending from 10,000 feet to 8,000 feet with an inbound speed of 300 KIAS?
• What must be done upon receiving an approach clearance while on a speed assignment?
• What is the significance of an Approach Light System in descent below MDA/DH?
• How does frost on the wing affect aircraft performance?
• Is communication required when entering a holding pattern during flight?
• What action is required if you are cleared to land but unsure about the runway conditions?
• What occurs if the pilot does not visually establish the runway environment by MDA/DH?
• Are cloud heights reported in AGL or MSL?
• What color are the threshold lights?
• What is a holdover time in aviation?
• What might lead to an increase in induced drag?
• What should a pilot consider regarding aircraft performance before a flight?
• Where can the highest obstacle on the approach chart typically be found?
• What is adverse yaw?
• What is the maximum speed allowed below Class Bravo airspace?
• What is the primary difference between turbulence and chop?
• What occurs when an aircraft exceeds the critical angle of attack?
• What do the runway centerline lights changing from white to alternating red and white indicate?
• Which scenario requires an alternate airport for a flight?
• If visibility falls to 1500' outside of the FAF, what must you do?
• How does an increase in density altitude affect aircraft performance?
• When flying into Burlington, VT in January, will the aircraft be higher or lower than indicated by the altimeter?
• What is needed when departing an airport with weather below IFR minimums?
• What does MSA stand for in aviation terminology?
• At what flight level does RVSM airspace begin?
• What is a microburst?
• What is the holding speed for an altitude between 6001 and 14000 feet?
• What speed would you fly while maintaining best forward airspeed inside Class Bravo airspace?
• What should a pilot do upon noticing smoke in the flight deck during descent?
• What does "Pilot’s Discretion to FL240" imply compared to "descend and maintain FL240"?
• What equipment is necessary to operate in RVSM airspace?
• What geographical area is typically covered by a TV?
• In what direction does the horizontal stabilizer produce lift?
• Which of the following describes the function of a Minimum Equipment List (MEL)?
• What does FAR 91.75 relate to in aviation?
• What factors should an airline consider when requiring an alternate airport during flight operations?
• What are the levels of ice accumulation during flight?
• What does the term "brief" refer to in the context of ILS?
• When beginning an approach, which is controlling: the ceiling, the visibility, or both?
• How is the time determined for holdover with deicing fluid?
• Which of the following is NOT a type of information a pilot should check prior to a flight?
• When transitioning back to visual conditions during an approach, where will the PAPI or VASI typically be located?
• What is the standard timing for the inbound leg of a hold below 14,000 feet?
• What is the purpose of an oil-to-fuel heat exchanger?
• What does the acronym FAF stand for in aviation?
• What is the primary purpose of sweeping the wings on an aircraft?
• What does APU stand for in aviation?
• What is the holding speed at MHA of 6000 feet?
• Which of the following is NOT a factor on the IMSAFE checklist?
• After passing the final approach fix, if tower reports visibility below minimums, what action should you take?
• How is a yaw damper used to overcome Dutch roll in swept-wing aircraft?
• After landing, what does a sign with a black background and a white numeral indicate?
• If ATC provides a clearance to cross MARRC intersection at FL180, do you still have to maintain that altitude after receiving a new clearance?
• Can the area behind a displaced threshold be utilized for takeoff?
• What must a pilot identify as they approach DA/MDA on an ILS approach?
• What factor determines the distance from the FAF to the runway on a profile view?
• Can you exit onto a crossing runway after landing?
• What is the significance of keying the mic on a certain frequency 3/5/7 times?
• What effect does a pilot’s stress have on performance?
• What would be an indicator of a microburst event?
• What is the purpose of windshear procedures?
• How long should a passenger wait to fly after diving if the dive required a controlled ascent?
• What is necessary to determine in the event of a missed approach regarding the holding fix?
• How is performance impacted by the need for holding at various altitudes?
• If the visibility falls below legal limits, what is the most appropriate action?
• At what altitude must the remaining pilot wear oxygen if the other pilot leaves the flight deck?
• What frequency would you attempt to contact on if you lost communication with ATC?
• What is the maximum speed limit in Class C and D airspace below 2500 feet AGL?
• In the context of aircraft performance, what does decreased drag lead to?
• What is the holding speed for altitudes above 14000 feet?
• What is the definition of a ceiling in aviation terms?
• What is the minimum fuel supply required for an IFR flight?
• How would you define a stabilized approach?
• Which of the following are levels of turbulence intensity?
• After landing, what does the runway edge lights changing from white to yellow indicate?
• What must a pilot have to continue the approach inside the FAF if visibility falls below prescribed limits?
• What should be the first action if smoke is noticed within the flight deck?
• You see a flashing white/white/green beacon while approaching Key West at night. What should you do?
• At what altitude would you intercept the glideslope on an approach plate?
• What is the standard volume of fog formation in relation to temperature?
• If you lose sight of the runway after descending below the DH, what action should you take?
• What area does the Minimum Safe Altitude (MSA) cover, and what obstacle clearance does it provide?
• At what vertical altitude does the speed limit of 250 KIAS apply?
• You are number one and holding short of the runway. What pavement markings do you see?
• If the temperature and dewpoint are within 2°C of each other, what weather phenomenon would you expect?
• What is the speed limit during a procedure turn?
• What does FAF signify during an ILS approach?
• What factor must be considered when responding to ATC speed commands?
• What is meant by 'current aircraft memory items'?
• How would you illuminate pilot controlled lighting?
• What is the maximum holding speed for aircraft entering a hold at 16,000 feet?
• In aviation, what does the acronym APU relate to?
• What is the purpose of design maneuvering speed in aviation?
• What is a possible consequence of rejecting a takeoff?
• What is the speed limit when entering a hold at 8000 feet?
• What color are the touchdown zone lights and how far do they extend down the runway?
• When is DME provided by the ILS?
• What is 15°C converted to Fahrenheit?
• Which of the following is critical during flight operations concerning weather evaluations?
• Which visual references are required to be visible to descend below MDA/DH?
• What type of information should a pilot familiarize themselves with before a flight?
• What is essential for briefing an Instrument Landing System (ILS)?
• What does V2 refer to during takeoff?
• What is the primary reason for filing an alternate airport for arrival?
• What is the benefit of flying in a tailwind?
• What is a Dutch roll in aviation?